Swarovski-optik EL Range User Manual download pdf (Page 16)

DEEN EN

7.4. Troubleshooting and display information

8. Maintenance and care

8.1. Lens-cleaning cloth

You can clean high sensitive lens surfaces with the enclosed

special microfibre cloth. It is suitable for objective lens, ocu-

lar lens and spectacles.

Please keep the cloth clean, as dirt can damage the lens

surface. If the cloth becomes soiled it can be washed in

lukewarm soapy water and left to dry. Please only use for

cleaning lens surfaces!

8.2. Cleaning

We have designed all elements and surfaces to require little

care.

To ensure the long-lasting optical brilliance of your binocu-

lars, you should keep the glass surfaces free of dirt, oil and

grease. When cleaning the lenses, first remove larger par-

ticles with an optical lens brush. For the subse-

quent thorough cleaning we recommend breathing

onto the lens surface to form a coat of condensa-

tion and then cleaning it with a soft, moist cloth.

The housing is best cleansed with a soft, moist cloth (don’t

use the lens-cleaning cloth).

In the event of hard-to-remove dirt (e.g. sand) the eye cups

can be unscrewed and cleaned easily.

Problem Probable Cause Remedy

The ﬁeld of view is

shaded at the

periphery (vignetted).

The eyecups have

not been adjusted

correctly for use with

or without spectacles.

Spectacle wearers

need to twist the eye-

cups right in to the

stop position. When

using without spec-

tacles, the eyecups

need twisting out to

the required position

(see chapter 3.1.).

The display shows

“----” for the distance

measured.

1. The measurement

range has been

exceeded.

2. The object is not

reﬂective enough.

3. Target out of focus.

1. See chapter 4.

2. See chapter 7.1.

3. See chapter 3.5.

The display shows

“co” for the distance

measured (clean

optic).

1. The distance to

the target is shorter

than the minimum

measurement range.

2. The objective lens

is dirty.

1. See Technical Data

Sheet.

2. Clean the objective

lens.

The aiming mark

ﬂashes when the

instrument is

switched on.

The battery is low. There is sufﬁcient

power for around 100

more measurements.

Replace the battery

or brieﬂy warm the

current one.

Display, aiming mark

and target are not all

in focus at same time.

Dioptric adjustment is

not optimal.

See chapter 3.4.

“Err” appears on the

display

Electronic fault Press the measure-

ment button again.

On repeated

occurrence of “Err”,

please contact

SWAROVSKI OPTIK

customer service.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 86 87

Comments to this Manuals

No comments

Swarovski-optik EL Range User Manual Page 16

Comments to this Manuals

Related products and manuals for Optical devices Swarovski-optik EL Range